Evergrip’s Flexible Bituminous Marker Adhesive is a sustainable hot-melt asphalt solution, crafted from recycled ground tire rubber.
This adhesive delivers a strong and lasting bond for pavement markers on various surfaces, including concrete and asphalt. It effectively adheres both ceramic and plastic markers to Portland cement concrete, asphaltic concrete, or chip-sealed roads. The formulation consists of a unique asphaltic blend, enriched with mineral filler.Â
Please note that the applicator must be purchased separately.
Documents: Safety Data Sheet
Limitations: Should not be heated above 400 degrees F.
Surface Preparation: Pavement surface should be dry, properly cleaned, and blown free of sand and other finely divided particles.
Working Conditions: Apply in normal dry working conditions when the ambient temperature is at least 40 degrees F.
Application: Melt product to desired consistency in a temperature-controlled heater applicator with a push bar for manual propulsion and steering, left/right dispensing valves, and a manual agitator system. Recommended application temperature is 375 degrees F. Dispense adhesive at desired intervals onto a clean, dry surface. Press the marker into the glue and allow it to dry for two minutes before subjecting the marker to traffic.
Coverage: 1 lb is sufficient to adhere to 2 1/2 markers.
Precautions: Use extreme care when handling the hot adhesive; avoid splashing material. If any hot adhesive should contact the skin, plunge the affected part immediately into cold water. Remove cooled asphalt from skin with mineral spirits or any other non-irritating solvent. Do not attempt to peel cooled asphalt off the skin. See a physician immediately. Do not take internally.
Box: 4 pieces
Weight: 44 lb
Flexibility: Superior Flexibility
Resistance: Superior Impact Resistance
